“Parting off” Tool for Emcoturn 120

Stel je vragen hier over draaibanken en cnc

Moderator: Moderators

Plaats reactie
Geko
Berichten: 16
Lid geworden op: 22 dec 2020 16:24

“Parting off” Tool for Emcoturn 120

Bericht door Geko »

Hallo and a happy new Year!
My Name is Georg from Germany, and I am new in this forum.
I hope it is welcome to write in English, because I am not very familiar with the Netherlands spelling.

I am finished with the retrofitting of my Emcoturn 120 with EdingCNC about one month ago.

Now I am looking for a parting off tool (left hand of course) with exchangeable blades which fit into the Emcoturn 120.

Does have somebody have a suggestion where I can order a tool like this?
Or does somebody can tell me what blades I need for this tool on the photo?
This tool came along with my lathe.

22244

Thanks in advance
Georg
hfjbuis
Donateur
Berichten: 3058
Lid geworden op: 13 feb 2017 00:26
Locatie: Hoensbroek

Re: “Parting off” Tool for Emcoturn 120

Bericht door hfjbuis »

Welcome @Geko
English and probably German is not a problem. But of course you will get more responses of Dutch posts.
You should consider a German forum. I Googled "cnc forum deutschland" and got a lot of hits.
Geko schreef: 01 jan 2021 17:09 Does have somebody have a suggestion where I can order a tool like this?
Or does somebody can tell me what blades I need for this tool on the photo?
This tool came along with my lathe.
It looks like a holder for SP200 (1.7 mm holder width) or SP300 (2.7 mm holder width) blades.

If so, it is an ZQ2020R alike holder. Just for an impression,
https://www.dennisdeal.com/products/zq2 ... dUQAvD_BwE

You should order a holder that has a shaft suitable for your lathe.
Geko
Berichten: 16
Lid geworden op: 22 dec 2020 16:24

Re: “Parting off” Tool for Emcoturn 120

Bericht door Geko »

Thanks for the quick reply!
The problem in the German forums is that the Emcoturn is not discussed very much.

Also thanks for the Link, but these tools doesn’t really fit. I think Emcoturn owner know what I mean,

groetjes
Geko
kgerrits
Berichten: 27
Lid geworden op: 04 mar 2014 16:33
Locatie: Waalre

Re: “Parting off” Tool for Emcoturn 120

Bericht door kgerrits »

Hi Geko,

I use this one on my emcoturn120:

https://www.ebay.com/itm/MGEHL1212-2-5- ... 2749.l2649

You need to grind a little off the bottom, and then it just fits.
Geko
Berichten: 16
Lid geworden op: 22 dec 2020 16:24

Re: “Parting off” Tool for Emcoturn 120

Bericht door Geko »

Hartelijk bedankt!
dan krijg ik er een van.

Geko
Plaats reactie